TRUCK & HOT TRACTOR PULL

6,000 lbs	4WD STREET STOCK TRUCK
6,200 lbs	4WD CHEATER STOCK TRUCK
5,500 lbs	NATURALLY ASPIRATED
6.500 lbs.	OPEN TRACTOR (V-8 ALLOWED)
9,500 lbs.	3,000 RPM
7,500 lbs	STOCK 4WD DIESEL TRUCK
9,500 lbs	HOT FARM TRACTOR
6,000 lbs	4WD MODIFIED STOCK TRUCK
9,500 lbs	LIMITED PRO TRACTOR
8,000 lbs	OPEN 4WD DIESEL
	SEMI--MALE
	SEMI--FEMALE

Sled Furnished By: Mighty Mac Pulling Sled

9, 500 Hot tractor rules

1. 20" Max Drawbar with 3" Hole
2. 20.8" Open Tires
3. Single Turbo
4. Wheelie Bars, Kill Switch, Scatter Blanket required

9, 500 Limited Pro tractor rules

1. 20" Max Drawbar with 3" Hole
2. 24.5.32" Open Tires
3. Single Turbo
4. Wheelie Bars, Kill Switch, Scatter Blanket required
5. Cast head and cast block
6. Floating pull
7. Roll cage required

Truck rules

6200LB "Cheater Sock" Gas 4x4

Engines & Drive Train

1. Blocks and heads must be cast iron.
2. Aluminum intakes, single four-barrel carburetors and EFI permitted.
3. 4500 series dominators, turbos and superchargers are not permitted.
4. Headers permitted must exit down and back through mufflers.
5. Engine must be same make as truck and in stock location.
6. 514 CU. IN. limit
7. Transmission and transfer case must be OEM, 1 ton or less.
8. Front and rear axles must be OEM, 1 ton or less.

Chassis

1. Factory and frames 1 ton or less required with coil or leaf springs. Must have at least (4) working leaf springs per side on rear.
2. Traction bars are permitted.
3. Rear suspension blocks are permitted w/ at least "1" of suspension travel.
4. Crew cab and extended cab trucks are permitted.

Weights

1. No front weights, heavy pipe bumpers, brush guards, or snow plows.
2. Weights must be secured in bed, not in a cab or in engine compartment.

Hitch

1. Hitch point must be a minimum of 48" from the center of the rear axle and a minimum of 26" high.
2. No part of hitch can extend forward past the center of the rear axle and no hitch adjustment permitted from rear end.

Truck

1. Must have complete factory sheet metal and windows.
2. No removing of bed floor.
3. Flat beds are permitted as long as they are factory built or heavier.
4. Fiberglass hoods and hood scoops permitted.
5. Batteries and fuel tanks must be in stock location or in bed of truck.

Tires

1. Any street legal dot approved tire is permitted.
2. Maximum tire size 36" tall x16" wide.
3. No cut or sharpened tires allowed.

Safety

1. No nitrous, all components must be removed.
2. Pump gas or racing gas only. No alcohol or nitro permitted.
3. Drive shaft loops, u-joint shields, blow- proof bell housing or transmission blankets are required and kill switches are mandatory for everyone's safety.

6000 lbs 4wd modified stock truck

Safety rules

1 Must have loops on all drive shafts and u-joint shields.3 on rear 2 on front.

2 Must have working kill switch .Will be checked. Kill switch must be in plain view
of sight. Kill switch must shut off fuel pump.

3. Must have neutral safety "white" light visible by sled operator.

4. Must have fire extinguisher within hands reach.

5. Blow proof bell housing or blanket and flywheel shields are insurance required.

6. Must wear helmet.

NO HOT RODDING IN PIT AREAS…

Body Rules

1. Must have all factory sheet metal. No fiberglass or aluminum body parts. Hood
Scoops are allowed. Do not have to have a tailgate on truck.

2. Maximum wheelbase is 135 inches.

3. Full factory stock bed - no flat beds or aluminum beds.

4. Must have factory bucket seats or bench seat. No racing seats allowed.

5. No extended cabs.

6. Inner fenders must be in truck in stock location.

7. Gas tanks must be in factory position or fuel cell only in bed of truck.

8. Must have at least one shock per wheel.

9. Must have drums and backing plates on back unless OEM disc brakes.

10. Battery must be secured under hood only.

11. Must have a minimum of 1 inch travel in rear of truck between axle stops and
Rear end housing. No solid suspensions. Springs must have a minimum of 5
Working leafs on each side. Springs must be in factory location.

12. Ladder bars may not extend past the front of bed on the rear or past the front
Cab mount on the front.

13. Maximum of 33 inch tall DOT tires mounted on 10 inch wide rims. No cut or
Sharpened tires. 33 x 12.50 or 30.5 x 75.

14. Front weights may not extend more than 60 inches forward of the center line of
The front axle if the truck has a wheelbase of 135" or 195 inches of the rear
Axle if the truck has less than 135" wheelbase.

15. Hitch will be 24 inch high maximum. No less than 36 inch from center of the
Rear axle to hook point. Hitch must fasten to frame only and adjust off the
Frame only. All bracing must hook to frame or stops that come off of frame
Only.

ENGINE RULES

1. Racing gasoline only. No power additives of any kind. Absolutely no nitrous
Oxide, alcohol or nitro, etc.

2. Engine must be same make of truck. Must be in factory stock location. Any
Internal modifications to engine are allowed.

3. 472 cubic inch limit.

4. Dry sump oil systems are not allowed.

5. One single carburetor - no dominators.

6. Aluminum intakes allowed. No external modifications. Maximum of 2"spacer
Between carburetor and intake. No tunnel rams or sheet metal intakes.

7. After market heads allowed. Must be cast iron block and heads. No aluminum
Heads or blocks.

8. Open headers allowed. All headers must be straight down and back cannot
Exit through hood.

9. Must have alternator. Alternator must be driven by crank.

10. Electric fuel pumps allowed. One fuel pump total. No belt drive pumps allowed.

11. Electric fans and water pumps are allowed.

12. Front end and rear end larger than one ton.

13. Transmission and transfer case must be OEM style of truck. No pro-fabs.

7500 lb stock 4x4 diesel truck

1. Truck must be registered and insured for street use. A license plate with a current sticker tag is required to be affixed to truck. Registration, license plate, and sticker tag must match.
2. Single turbo charger only permitted. Maximum 2.8 housing. Turbos will be
inspected at official's discretion; failure to allow for turbo inspection will result in
immediate disqualification from the class with no refunds allowed.

3. No studded tires. Tire chains or any tire NOT specifically intended for street use
are permitted . All tires must carry a dot number on the side wall; dot number
must be easily read from the outside of the tire. No cut, altered, or sharpened
tires. No tire size limits. Trucks with dual rear wheels may enter and run in this
class.

4. Front bumpers must be unaltered factory stock. No weighted front devices are
Permitted-but is not limited to: homemade bumpers. Snowplow frames. Brush
Guards and winches. Lower brackets only for snowplow frames are permitted so
So long as no modifications that would add weight are determined. A truck is
Permitted to compete without a front bumper. Absolutely no hanging weights
allowed.

5. The hitch point will be from a reese type hitch on a level plane and with the point
Of attachment to the trucks frame behind the pumpkin of the rear end. No other
Types of hitches are permitted. Hitch point may not be more than 26" from
Ground. No angled, lever, pivot, axis or other types of trick hitches are allowes
And the hitch must be stationary in all directions. The hook must be past the
Bed of the truck if there is no bumper or past the end of the bumper. Each truck
Driver must supply a twisted clevis. The hitching point must accommodate a Minimum of 3.5 inches across.

6. Pump diesel is the only fuel permitted. Computer boxes, programs, chips are
Permitted. Torque plates are permitted. Fuel injector modifications are
Permitted. Superchargers are not permitted.

7. No solid suspensions are permitted. Suspensions must have a minimum of 2"
Of movement at all times. No blocks are permitted between axle housings and
Truck frame that would restrict the necessary 2" of movement. Lift kits are
Acceptable.

8. Truck must be stock in appearance. Floor in bed must be solid. The wheelbase
may not be changed from original manufacturer. Wooden flat beds are permitted.
Extended cabs are allowed.

9. The transmission and transfer case must be OEM and available in one-ton(or smaller) pick-up trucks.

6,000 lbs 4wd street stock truck

1. Must be street legal. Trucks must be registered and insured for street use. A
License plate with a current sticker tag is required to be affixed to truck.
Registration, license plate and sticker must match.

2. No studded tires, tire chains or any tire not specifically intended for street use
Are permitted. No cut, altered or sharpened tires. No tire size limits.

3. Front bumpers must be unaltered factory stock. No weighted front devices.
Absolutely no hanging weights allowed.

4. The hitch point will be from a reese type hitch on a level plane. 26" hitch
Height. Hitch must be stationary in all directions. Hitch point must be a
Minimum of 48" from center of rear axle.

5. No solid suspensions. Suspension must have a minimum of at all times.

6. Truck must be stock in appearance. Floor in bed must be solid. The wheelbase
may not be changed from original manufacturer. Extended cabs are allowed.

7. The transmission and transfer case must be OEM and available in one-ton or
smaller pick-up trucks.

8. No aluminum intakes or headers unless factory equipped.

8,000 lb open 4x4 diesel

1. 26" hitch max

2. All safety shields, bell housing, blankets, and kill switches are required.

3. NO CRYING!!!!!!!!!!!!

9,500 lb 3,000 RPM

1.20" Drawbar
2. Tire size 20.8
3. Any Cut Tires Allowed
4. 3,000 RPM Maximum
5. No Speed Limit
8. Trucks will be checked before they are hooked to the sled

NOT RESPONSIBLE FOR ACCIDENTS